How to install OPCOM VAUX-COM 120309a software on WIN10

This toturial is about  how to step by step install OPCOM diagnostic interface VAUX-COM 120309a software driver on Windows 10, especially for those troubled with “OP-COM usb is not detected on Windows 10”.

Run VAUXCOM.exe

Allow this app to make changes to your device

OPCOM VAUX-COM 120309a software on WIN10 (1)

Go to Settings in VAUX-COM 120309a

吧   OPCOM VAUX-COM 120309a software on WIN10 (2)

Test interface

test-interface

Connect the interface to the USB port, or install the USB driver

install-usb-driver

Close VAUX-COM 120309a

Opcom Computer management

Launch the troubleshooter

launch-the-troubleshooter

Again, open Computer management

Uninstall USB Serial Converter

Uninstall-USB-Serial-Converter

Disconnect the internet

Update driver- OP-COM USB V2

install-driver-op-com

Browse my computer for driver software

browse-driver-software

browse-driver-software 2

browse-driver-software 3

browse-driver-software 4

browse-driver-software 5

browse-driver-software 6

browse-driver-software 7

browse-driver-software 8

Continue installing this driver

install-this-driver

usb-driver

check-connection

Again, run VAUXCOM.exe as administrator

Allow this app to make changes to your device

Go to Settings

Then Test interface

Firmware version tested successfully

firmware-tested

Apply settings

apply-setting

Go to Diagnostics

go-to-diagnosis

select-vehicle

select-car-to-test…

Successfully install Op-Com on Windows 10!!

 

http://obdexpresscouk.blogspot.com/2017/06/how-to-install-opcom-vaux-com-120309a.html

Leave a Reply

Your email address will not be published. Required fields are marked *